Antistain Water oilrepellent Block D70 Eco Bellinzoni

Antistain Water oilrepellent Block D70 Eco Bellinzoni Lt.1

Antistain Water oilrepellent Block D70 Eco by Bellinzoni with natural effect used to protect surfaces in marble, granite, terracotta, natural stone, ceramic and stoneware. Product able to prevent the penetration of water, oil, food fats and moisture. BLOCK D70 ECO PLUS prevents the formation of mold and is approved for food contact

CHEMICAL

• Liquid: Appearance
• Transparent: Opalescent
• Specific weight at 20 °C 1,00±0,05
• Hydro-solubility: Soluble in every ratio
• Ph: 7,00 ±0,02
• Drying time at 20 °C (68 ° F) 45-60 minutes *
• Hard Dry:8 hours *
• Complete drying time: 24 Hours 

INSTRUCTIONS FOR USE

• Surface must be thoroughly clean and dustless. It is possible to treat also wet surfaces.
• Lay BLOCK D70 ECO PLUS evenly on the surface to be protected, using a brush, roll, dry cloth, spreading fleece or mop.
• Let the product work for 3-5 minutes and then apply a second layer crossed to the first.
• During the application and subsequent drying, temperature of the substrate should be between 10 and 30°C.

DIRECTIONS FOR USE

• Product is ready for use; do not dilute it.
• On very absorbent material it is suggested to make a second application after 10 minutes from the first.
• On extremely absorbent materials like terracotta or sandstone, it is suggested to apply 3 layers.
• It is possible to apply the product on wet surfaces.
• For small pieces of stone it is possible to treat it by immersion and it is also possible to use a sponge damped with BLOCK D70 ECO PLUS and apply it on the material.
• Once treated, the material have to dry for 24 hours until the polymerization of the chemical is complete.
• In case of treatment of statues, decorations etc. pay attention to reach well the cavities and corners.
• In case too much product has been applied, it is possible to remove the excess by rubbing with a damp cloth.
• Read carefully recommendations printed on label and perform a preliminary test on a small area before actual use.

AREAS OF APPLICATION

Marble, granite, terrazzo, marble-agglomerate quartz-agglomeration, stone, limestone, sand stone, gres.

TOOLS FOR APPLICATION

Brush - Roller - Vello spreader - Mop - spray dispenser

APPROXIMATE COVERAGE PRODUCT

For protection of marble and granite, with 1 litre (1 quart) of product is possible to treat 15/25 sqm (160/270 sq.ft.), depending on type and surface finish of material.

Maintenance

For proper maintenance of the treatment we recommend to carry out periodic washing with our LEM-3 neutral detergent, diluted with water according to the amount of dirt to be removed, without using abrasive tools. The treatment has a variable duration, depending on weather condition it is exposed to and wear of the material. If necessary, it is possible to reapply BLOCK D70 ECO PLUS above a previous application